top of page

Why Dry Firing Will Ruin Your Air Rifle (And What to Look Out For)

Oct 5
2 min read

If you own a spring-powered air rifle, there is one thing you must never do — fire it without a pellet in the breech. It sounds like a small oversight, but dry firing is one of the most common ways shooters unknowingly destroy their guns. This guide explains exactly what happens inside the action, which types of airgun are most at risk, how to tell if the damage has already been done, and how to make sure it never happens.

What Is Dry Firing?

Dry firing means releasing the trigger on a cocked airgun without a projectile in the barrel. It can happen accidentally — you thought you had loaded, or you were testing the trigger pull. For most spring-powered airguns, it is a serious mechanical event. The pellet is not just ammunition; it is part of the mechanism that prevents the action from harming itself.

What Dry Firing Does to a Springer

When you fire a spring-piston air rifle, the spring releases and drives the piston forward through the compression chamber at high speed. Normally, the pellet in the breech resists the compressed air just long enough to create back-pressure — that cushion of air absorbs the kinetic energy of the piston. Without a pellet, there is no resistance. The piston slams forward at full force and crashes into the end of the compression chamber with nothing to cushion the blow. The damage this causes can include piston seal damage, spring damage, and in lower-quality guns, physical deformation of the compression chamber. One dry fire may not destroy the gun outright, but it can dramatically shorten its working life.

CO2 Airguns: Different Risk, Still Real

CO2 guns work on a completely different principle but dry firing them is still not recommended. The main risk is O-ring damage. Firing without a projectile means the valve releases gas with nothing to accelerate, which can cause pressure irregularities that stress the seals over time.

PCP Airguns: Generally Safer, But Still Not Recommended

Pre-charged pneumatic (PCP) airguns are a different story. Because the pellet does not provide back-pressure in the same way, dry firing a PCP is far less destructive. Some manufacturers explicitly state their PCPs can be dry fired safely. Most still advise against it on general principle. If you are practising trigger technique, a dummy round is still the better choice.

Signs Your Gun Has Been Dry Fired

  • Velocity drops — inconsistent groups at distances that used to be no problem

  • Unusual report — a hollow clunk rather than the usual crisp discharge

  • Inconsistent recoil — the shot cycle feels sluggish or irregular

  • Oil or residue around the breech — can indicate a damaged piston seal venting gas backwards

How to Prevent It

The single most effective habit: check the breech before cocking. The correct sequence is load the pellet, then cock the action. Many people do it the other way round, which is when an accidentally triggered pull does the damage. For trigger practice without live ammunition, use snap caps or dummy pellets — inexpensive and widely available in both .177 and .22.

 
 
 

Comments


bottom of page